Concrete Surface Anchor Kits for Commercial Mats

Anchor kits contain 4 screws & 4 anchors

5'L Mats have 4 grommet holes

10'L Mats have 6 grommet holes

15'L Mats have 8 grommet holes

20'L Mats have 10 grommet holes

25'L Mats have 12 grommet holes

30'L Mats have 14 grommet holes

2-year manufacturer's warranty 

INSTALLING
ON CONCRETE OR MASONRY SURFACE:

1.Place all mats in their final use
positions.

2.For each mat, mark the center of
all 4 corner grommets on the surface, then move the mats aside so the anchor
holes can be drilled.

3.Using a 5/16” diameter masonry
bit and drill, drill a 2” deep hole at each mark.

4.Blow the masonry dust our of each
hole.  A “Duster”-type compressed gas can works well for this.

5.Place one anchor in each hole and
tap until flush or below flush with a hammer.

6.Replace the mats in position,
insert a screw in each anchor, and install with a Phillips screwdriver.

When
storing the mats for the off-season, replace the screws in the anchors to keep
out debris.